Leak Testing Machine 1457

The leak testing machine 1457 is a unit to check two chambers. One high-pressure chamber and the other a low-pressure chamber. Provided with a label issuer, which dispenses a label only when the part

Manual Leak Testing Device 1440

Manual leak testing device 1440 for closing the screwed part, both closures and plugs. When the part geometry is more simple, we normally use manual clamps to facilitate closing without the use of tools.

Leak Testing Machine With Closing Sequence

Leak testing machine with closing sequence. This application has a set of hydraulic closing units, supported on fastening points of the crankcase. These closing units operate following the bolting sequence of the crankcase. Hence,

Leak Testing and Pokayoke

Leak testing and Pokayoke. Leak testing machine with ATEQ leak tester with flatness checking using measuring pencils, checking of presence-absence of holes, and loading and unloading. The machine has three stations: Station 1: Loading,

Leak Testing and Fitting

Leak testing and fitting. Machine with three stations and horizontal handling device, with manual loading and automatic unloading. Loading station: – Fitting of bearing and seal ring, with force and fitting control. – Leak

Dual-Camera Leak Testing

Dual-camera leak testing. The leak testing machine is provided with two ATEQ leak testers, one for each camera. One camera performs the test at low pressure and the other at high pressure.

Double Leak Testing Machine

Double leak testing machine with a quadruple handling device to load and unload parts in pairs. It holds two ATEQ leak testers: one for each part. The handling device is servo-controlled and the stop